Expand this Topic clickable element to expand a topic
Skip to content
Optica Publishing Group
  • CLEO/Europe and IQEC 2007 Conference Digest
  • (Optica Publishing Group, 2007),
  • paper CA6_4

High power in-band pumped Er:YAG laser at 1617 nm

Not Accessible

Your library or personal account may give you access


Laser sources operating in the eyesafe wavelength regime around 1.5-1.6 μm have applications in a number of areas including, remote sensing, ranging and free-space communications. For many of these applications, the requirement for high output power is often supplemented by the need for high efficiency and good beam quality. This combination of operating characteristics is very difficult to achieve in conventional diode-pumped solid-state lasers based on erbimn doped crystals (sensitised with Yb) owing to the relatively high fractional heat loading which results from the large quantum defect (~ 40%) and energy-transfer-upconversion. To alleviate this problem, attention has recently turned to singly-doped crystals (e.g. Er:YAG) and in-band pmnping using an Er,Yb fibre laser. This approach has the advantage that most of the waste heat is generated in the fibre, which is largely immune to thermal effects, and quantum defect heating in the Er-doped crystal is very small (~7%). Using this hybrid laser scheme, we have demonstrated ~60 W of continuous-wave output from an Er:YAG laser at 1645 mn with a slope efficiency of 80 %1. However, for some remote sensing applications this operating wavelength is a little inconvenient, since there are atmospheric absorption lines due to methane which are in very close proximity necessitating careful selection and control of the lasing wavelength. Er:YAG also has a transition from the same upper level manifold (4I13/2) at 1617 nm, which lies in a region of the spectrum where there are no atmospheric absorption lies. However, this transition has a much more pronounced three- level character and hence a much higher threshold pmnp power, so it has received little attention in spite of its obvious advantages for certain applications. Here, we report preliminary results for power scaling of an Er:YAG laser at 1617 mn in-band pumped by a high-power cladding-pumped Er,Yb fibre laser.

© 2007 IEEE

PDF Article
More Like This
Resonantly pumped 1645nm and 1617nm Q-switched Er:YAG ceramic lasers

Q. Ye, S. Wang, Y. Shi, M. Gao, C. Gao, and J. Zhang
CA_P_18 The European Conference on Lasers and Electro-Optics (CLEO_Europe) 2015

1617-nm Er:YAG Laser with Direct Resonant Laser Diode Pumping

Dmitri Garbuzov, Igor Kudryashov, and Mark Dubinskii
MF17 Advanced Solid-State Photonics (ASSP) 2005

Diode-pumped 1617 nm Er:YAG laser with micro-pulling down single-crystal fibers

Igor Martial, Adrien Aubourg, Julien Didierjean, Nicolas Aubry, François Balembois, and Patrick Georges
AT4A.1 Advanced Solid-State Photonics (ASSP) 2012


You do not have subscription access to this journal. Citation lists with outbound citation links are available to subscribers only. You may subscribe either as an Optica member, or as an authorized user of your institution.

Contact your librarian or system administrator
Login to access Optica Member Subscription

Select as filters

Select Topics Cancel
© Copyright 2022 | Optica Publishing Group. All Rights Reserved