Abstract
Extrinsic Fabry-Perot interferometric (EFPI) pressure sensors are a key asset in a number of applications, including medical devices, life science, oil&gas, and energy plants [1]. EFPI probes, as in Fig. 1A, are based on creating an air-gap cavity L within an optical fiber structure, acting as a Fabry-Perot resonator; the fiber tip d acts as a diaphragm, compressing the air gap as a function of the pressure applied on the fiber surface. The sensitivity of EFPI probes is strongly dependent upon diaphragm thickness, which is approximately proportional to d−3, and ranges from 0.01 nm/kPa to 10 nm/kPa. An accurate optimization of the diaphragm length is required to match target performances, in terms of sensitivity, pressure accuracy, and working range [2]. Hydrofluoric acid (HF) is employed for diaphragm shrinking, as it allows controlled glass fiber etching while maintaining polishing quality; however, HF etching rate is poorly repeatable, leading to a poorly predictable diaphragm length. Industrially, this problem has highly affected probes performance repeatability.
© 2013 IEEE
PDF ArticleMore Like This
Sven Poeggel, Daniele Tosi, Gabriel Leen, and Elfed Lewis
87970B European Conference on Biomedical Optics (ECBO) 2013
S. Poeggel, D. Tosi, G. Leen, and E. Lewis
CH_6_4 The European Conference on Lasers and Electro-Optics (CLEO/Europe) 2013
Kent A. Murphy, Michael F. Gunther, Anbo Wang, Richard O. Claus, and Ashish M. Vengsarkar
P30 Optical Fiber Sensors (OFS) 1992