Abstract

A significant limitation in the detection and spectroscopy of individual dye molecules in liquid room temperature samples is the loss of fluorescence signal through chromophore photobleaching. Although often considered a fundamental restriction on sensitivity, it has been shown that the probability per excitation cycle of photobleaching may be reduced by enhancing the spontaneous emission rate of the chromophore located inside a microdroplet, which acts as a optical cavity. Studies of glycerol microdroplets containing R6G dye molecules, and levitated in a three-dimensional electrodynamic trap, have demonstrated a significant enhancement of both the fluorescence decay rate [1] and the total fluorescence yield [2] of the chromophore. Modification of the emission rate is greatest for molecules located near the surface of small (< 10 μm) microdroplets, where the influence of the droplet cavity modes of the droplet is most significant. To exploit this surface sensitivity, surfactant forms of rhodamine dyes were recently studied [3]. Fluorescence emission of the dye molecules, constrained to the droplet surface and with fixed transition moments perpendicular to the surface normal, were shown to be significantly enhanced at small droplet sizes. Additionally, at larger droplet sizes corresponding to higher droplet Q’s, preferential emission into the cavity modes was observed, however the detection of fluorescence photons was delayed by the storage time of the cavity, which may be on the same order as the fluorescence lifetime. These measurements, performed on relatively concentrated dye solutions, suggest that microcavity effects may be exploited to greatly enhance single molecule detection sensitivity in glycerol microdroplets. Furthermore, the large cavity storage time of the high-Q droplets opens the possibility for re-excitation of the molecule following emission into the droplet resonance, and subsequent stimulated emission, that is, single-molecule lasing.

© 1998 Optical Society of America