Abstract

We discuss the behavior of the refractive index of a typical epoxy–aromatic diamine system. Near 850 nm the index of refraction is found to be largely controlled by the density of the epoxy. Models are derived to describe its dependence on temperature and extent of cure. Within the range of temperatures studied, the refractive index decreases linearly with increasing temperature. In addition, as the epoxy is cured, the refractive index increases linearly with conversion to the gel point. From then on, shrinkage in the volume of the epoxy is restricted by local viscosity. Therefore the linear relationship between the refractive index and the extent of cure does not hold beyond the gel point.

© 1995 Optical Society of America

Fiber-optic epoxy composite cure sensor. II. Performance characteristics

Kai-Yuen Lam and Martin A. Afromowitz
Appl. Opt. 34(25) 5639-5644 (1995)

Contactless optoelectronic technique for monitoring epoxy cure

Andrea Cusano, Vincenzo Buonocore, Giovanni Breglio, Antonio Calabrò, Michele Giordano, Antonello Cutolo, and Luigi Nicolais
Appl. Opt. 39(7) 1130-1135 (2000)

Optical Refractive Index of Air: Dependence on Pressure, Temperature and Composition

James C. Owens
Appl. Opt. 6(1) 51-59 (1967)

Refractive-index measurements in freezing sea-ice and sodium chloride brines

G. A. Maykut and B. Light
Appl. Opt. 34(6) 950-961 (1995)

Effect of external index of refraction on multimode fiber couplers

George Z. Wang, Kent A. Murphy, and Richard O. Claus
Appl. Opt. 34(36) 8289-8293 (1995)