Abstract

The use of a range of optical techniques to monitor the process of fabricating optical fiber tapers is investigated. Thermal imaging was used to optimize the alignment of the optical system; the transmission spectrum of the fiber was monitored to confirm that the tapers had the required optical properties and the strain induced in the fiber during tapering was monitored using in-line optical fiber Bragg gratings. Tapers were fabricated with diameters down to 5 μm and with waist lengths of 20 mm using single-mode SMF-28 fiber.

© 2015 Optical Society of America

Simultaneous measurement of strain and temperature by two peanut tapers with embedded fiber Bragg grating

Lingya Lv, Sumei Wang, Lan Jiang, Fei Zhang, Zhitao Cao, Peng Wang, Yi Jiang, and Yongfeng Lu
Appl. Opt. 54(36) 10678-10683 (2015)

Temperature sensing through long period fiber gratings mechanically induced on tapered optical fibers

María Guadalupe Pulido-Navarro, Ponciano Jorge Escamilla-Ambrosio, Sigifredo Marrujo-García, José Alfredo Álvarez-Chávez, and Fernando Martínez-Piñón
Appl. Opt. 56(19) 5526-5531 (2017)

Carbon dioxide laser fabrication of fused-fiber couplers and tapers

Timothy E. Dimmick, George Kakarantzas, Timothy A. Birks, and Philip St. J. Russell
Appl. Opt. 38(33) 6845-6848 (1999)

Precise control of the optical microfiber tapering process based on monitoring of intermodal interference

Yang Yu, Xueliang Zhang, Zhangqi Song, Jianfei Wang, and Zhou Meng
Appl. Opt. 53(35) 8222-8228 (2014)

Tapering fibers with complex shape

S. Pricking and H. Giessen
Opt. Express 18(4) 3426-3437 (2010)