Abstract
A semi-transparent metallic film and a high optical absorbing film were constructed with stacking metallic films. Both films were used as cathodes for polymeric light-emitting diodes (PLEDs). The semi-transparent film was made of gold/aluminum/gold thin multilayers with its optical transparency of the device reaches as high as ~70% in the visible region without capping layer, and the electrical sheet resistance reduces below 10 Omega/square. During illumination of the PLED, there was approximately 47% of light emitting from the top of the cathode surface, and 53% of light from the ITO side. The high optical absorbing film, also refer to as the black cathode, was constructed with four alternating layers of aluminum-silver, each aluminum or silver layer is 4 nm thick. The PLED with this black cathode demonstrated 126% enhancement of contrast under 1000 lx ambient illumination. The physical properties of these two cathodes were characterized by current-voltage measurement and atomic force microscopy. Ultraviolet-visible transmission spectroscopy and X-ray photoemission spectroscopy were also used to characterize the semi-transparent cathode and the black cathode respectively. For polymer light-emitting device,it is believed that morphology modification at each interface of the cathode plays a crucial role in determining the optical properties and conductivity of the over cathode.
© 2005 IEEE
PDF Article
More Like This
Cited By
You do not have subscription access to this journal. Cited by links are available to subscribers only. You may subscribe either as an Optica member, or as an authorized user of your institution.
Contact your librarian or system administrator
or
Login to access Optica Member Subscription
Add to BibSonomy