Abstract
During the last couple of years, quantum cascade (QC) lasers have reached a high degree of maturity. Yet, there are still several interesting spectroscopic applications which require higher average output powers than currently available. Consequently, we present here single-mode QC lasers in different configurations and with greatly improved average powers. The active region of the first investigated device consists of three coupled quantum wells with a diagonal electronic transition at 121 meV. Without epitaxial overgrowth on the 1st order grating and using a lateral contact scheme [1], we fabricated 1.5 mm long and 55 μm wide DFB lasers from this material; the resulting L-I-V-curves are shown in figure 1. The threshold current at room temperature was 5.5 A, corresponding to a threshold current density of 6.6 kA/cm2; at 1.5 % duty cycle and 300 K, the peak output power was on the order of 230 mW. The maximum average power output was achieved with a duty of 3 %. At −30 °C, an average power of 14 mW was seen, while at 60 °C, the power dropped to 1.5 mW. From the dependence of the threshold current we found a T0 value of 300 K; this is possible because of an improved match between Bragg and gain peak at elevated temperatures. The inset of figure 1 shows the emission spectra of this laser at different temperatures. The wavelength changes linearly at a rate of Δk/ΔT=−0.078 cm−1/K. We explain this augmented temperature tuning rate by strong heating effects of the device at high duty cycle.
© 2000 IEEE
PDF ArticleMore Like This
J. D. Bruno, R. Q. Yang, J. L. Bradshaw, J. T. Pham, and D. E. Wortman
FC2 Laser Applications to Chemical and Environmental Analysis (LACSEA) 2000
Clément Faugeras, Sébastien Forget, Carlo Sirtori, Jean-Yves Bengloan, Olivier Parillaud, Michel Calligaro, Marcella Giovannini, and Jerôme Faist
CMO6 Conference on Lasers and Electro-Optics (CLEO:S&I) 2005
Claire Gmachl, Rüdeger Köhler, Federico Capasso, Alessandro Tredicucci, Albert L. Hutchinson, Deborah L. Sivco, James N. Baillargeon, and Alfred Y. Cho
CWF1 Conference on Lasers and Electro-Optics (CLEO:S&I) 2000